Psion EP10 - Page 194

Chapter 5: Settings
Scanner Settings
Psion EP10 Hand-Held Computer User Manual
180
Enabled
This parameter must be set to on in order for EP10 to recognize the device connected to the Port Replicator
9-pin (COM5).
Power (COM6 only)
Pin 9 on EP10 COM6 is reserved for 5V power out and is defaulted to OFF. This parameter must be set to on
to enable power to a Snap Module or Vehicle cradle.
Baud
Double-tapping on this parameter displays a pop-up window in which you can choose an appropriate rate of
data transfer.
Figure 5.1 Port Baud Rates
Data Bits
This parameter determines the number of data bits included in each asynchronous data byte. Most devices
use 8-bit data bytes. Double-tapping on this option displays a pop-up window in which you can choose
either 7 or 8 data bits.
Parity
This parameter determines the type of parity checking used on the data going through the port replicator
port. Double-tapping on this option displays a pop-up window in which you can choose the appropriate
parity.