I/O Interface
128 QL-30/60 User Guide
9 JOBRDY Print job ready
Print jobs are stored in the
print module.
+24 V on Pin 9
Bit 1 User Bit 1 is set
10 READY Printer is ready +24 V on Pin 10
Bit 2 User Bit 2 is set
11 - - Do not use
12 REPRINT The last printed label will be
repeated.
+24 V between Pin
12 and Pin 25
13 START Print start signal
only for Print on demand =
On
+24 V between Pin
13 and Pin 25
14 PAUSE Pause ON/OFF Pause ON when +24
V between Pin 14
and Pin 25
15 RIBWARN Warning end of ribbon
The ribbon supply roll
diameter has undershot a
predefined level
0 V on Pin 15
16 LBLREM Label removed
For peel-off mode only.
Confirmation of the superior
control that the label has
been taken from the peel-off
position.
Required for the validity of a
new start signal.
Switch on +24 V
between Pin 16 and
Pin 25
17 JOBDEL Cancel print job
The current print job is
canceled and deleted from
the print buffer.
Switch on +24 V
between Pin 17 and
Pin 25
Table 45: Pin assignment of the I/O interface (Continued)
Pin Signal Name Description
Activation / Active
State
To Next Page
Loading...
