Configuration
80 QL-30/60 User Guide
Print speed Basic print speed setting.
The print speed can be re-specified for
each print job via software. The basic
setting is not changed by this.
The print speed setting also affects the
test printouts.
50 mm/s
Print position X Shifting of the entire print image
perpendicular to the direction of paper
flow.
The absolute shifting is limited by the
margins of the print zone. Those are
determined by the width of the printing
line on the printhead.
The setting can also be adjusted by the
software. The settings of configuration
and software are added together.
0.0 mm
Print position Y Shifting of the entire print image in the
direction of paper flow. With positive
values, printing begins later in the
direction of paper flow.
Shifting of the print image in the
direction of paper flow also influences
the peel and cut positions.
• Correct the Peel position and Cut
position parameters by the same
value in the opposite direction.
The setting can also be adjusted by the
software. The settings of configuration
and software are added together.
0.0 mm
Table 20: Parameters of the Setup > Printing menu (Continued)
Icon Parameter Meaning Default
To Next Page
Loading...
Need help?
General
