Alteon Application Switch Operating System Application Guide
Server Load Balancing
242 Document ID: RDWR-ALOS-V2900_AG1302
When editing the existing configuration, the current configuration is displayed in square brackets [ ]
to facilitate the update. To clear the existing configuration of the page name and page type, enter
“None”.
Note: Using these commands results in path modifications only. The protocol (HTTP or HTTPS) and
the port (when specified) are not modified.
To hide page locations
1. Ensure that Alteon is configured for basic SLB:
— Assign an IP address to each of the real servers in the server pool.
— Define an IP interface.
— Define each real server.
— Assign servers to real server groups.
— Define virtual servers and services.
2. Access and then enable URL path change:
3. Enter the hostname type and path type to be matched.
Example
In all URLs in the server responses that use www.site.com/test/, "test" should be removed from
the path. For example, when www.site.com/test/a/page.html appears in the response, it is
translated to www.site.com/a/page.html.
Client requests are modified the opposite way. For example, a request from the user to
www.site.com is modified and sent to the server as www.site.com/test. A request to
www.site.com/my.page is modified to www.site.com/test/my.page.
>> Main# /cfg/slb/virt 1/service 80/http/pathhide
>> Enter enabled/disabled or clear [e:d:c] [e]: e
>> Enter hostname match type [sufx:prefx:eq:incl:any] [any]:
>> Enter hostname to match:
>> Enter path match type [sufx:prefx:eq:incl:any] [any]:
>> Enter path to remove:
To Next Page
Loading...
