Alteon Application Switch Operating System Application Guide
Server Load Balancing
Document ID: RDWR-ALOS-V2900_AG1302 243
To perform this action, use following configuration:
Replacing Free Text in Server Responses
Alteon lets you remove or replace free text in server responses.
To replace free text in server responses
1. Ensure that Alteon is been configured for basic SLB:
— Assign an IP address to each of the real servers in the server pool.
— Define an IP interface.
— Define each real server.
— Assign servers to real server groups.
— Define virtual servers and services.
2. Access and enable URL path change, and define the action type.
3. Depending on the action type, enter the required parameters.
Example
To remove the text "this is a dummy line" from server responses, use the following configuration:
>> HTTP Load Balancing# pathhide
Note: The match condition applies to the response.
Current path hide (obfuscate) configuration: disabled
Enter enabled/disabled or clear [e|d|c] [c]: e
Enter hostname match type [sufx|prefx|eq|incl|any] [any]: eq
Enter hostname to match []: www. site.com
Enter path match type [sufx|prefx|eq|incl|any] []: prefx
Enter path to remove []: test
>> Main# /cfg/slb/virt 1/service 80/http/textrep
>> Enter status enabled/disabled or clear [e:d:c] [d]: e
>> Enter action [replace:remove] []:
Table 25: Replacing Free Text in Server Responses Action Parameters
Action Action Parameters
Remove The matched text to be removed:
>> Enter text to remove []:
Replace The matched text to be replaced:
>> Enter text to be replaced []:
>> Enter new text[]:
To Next Page
Loading...
