Alteon Application Switch Operating System Application Guide
ADC-VX Management
Document ID: RDWR-ALOS-V2900_AG1302 443
To load an AlteonOS image
1. Access the Active Switch Configuration Boot menu.
2.
Enter gtimg to load the AlteonOS image.
To load an ADC Application image to a vacant image bank
1. Access the Active Switch Configuration Boot menu.
2.
Enter gtimg to load the ADC application image.
>> Global - Main# /boot
------------------------------------------------------------
[Boot Options Menu]
single - Switch between ADC-VX and Standalone
vadc - Restart selected vADC process
dimage - Select default image
image - Select software image to use on next boot
conf - Select config block to use on next boot
gtimg - Download new software image via FTP/TFTP/SCP
reset - Reset switch
cur - Display current boot options
logen - Enable/Disable Enhanced Log Size
>> Global - Boot Options#gtimg
Enter image type [all|vx|adc]: adc
Enter image ID to be replaced: (1-10)
>> Global - Main# /boot
------------------------------------------------------------
[Boot Options Menu]
single - Switch between ADC-VX and Standalone
vadc - Restart selected vADC process
dimage - Select default image
image - Select software image to use on next boot
conf - Select config block to use on next boot
gtimg - Download new software image via FTP/TFTP/SCP
reset - Reset switch
cur - Display current boot options
logen - Enable/Disable Enhanced Log Size
To Next Page
Loading...
