Radware Alteon - Page 677

Alteon Application Switch Operating System Application Guide
Firewall Load Balancing
Document ID: RDWR-ALOS-V2900_AG1302 677
4. Configure static routes on the secondary clean-side Alteon.
5. Apply and save the configuration, and reboot Alteon.
Verify Proper Connectivity
To verify proper configuration at this point in the process, use the ping option to test network
connectivity. At each Alteon, you should receive a valid response when pinging the destination
addresses established in the static routes.
For example, on the secondary clean-side Alteon, the following commands should receive a valid
response:
Configure VRRP on the Secondary Dirty-Side Alteon
The secondary dirty-side Alteon must be configured with the primary as its peer. Once this is done,
the secondary Alteon receives the remainder of its configuration from the primary when
synchronized in a later step.
In this example, the secondary Alteon is configured to use primary dirty-side Interface 1 as its peer.
>> /cfg/l3/frwd/route
>> # add 10.10.2.1 255.255.255.255 10.10.3.3 2
>> # add 10.10.2.2 255.255.255.255 10.10.3.4 3
>> # add 10.10.2.11 255.255.255.255 10.10.3.3 2
>> # add 10.10.2.12 255.255.255.255 10.10.3.4 3
>> # apply
>> # save
>> # /boot/reset
>> # ping 10.10.2.1
Response; 10.10.2.1: #1 OK, RTT 1 msec.
>> # ping 10.10.2.2
Response; 10.10.2.2: #1 OK, RTT 1 msec.
>> # ping 10.10.2.11
Response; 10.10.2.11: #1 OK, RTT 1 msec.
>> # ping 10.10.2.12
Response; 10.10.2.12: #1 OK, RTT 1 msec.
>> # /cfg/l3/vrrp/on
>> # /cfg/slb
>> # on
>> # sync/peer 1
>> # addr 195.1.1.10
>> # ena
>> # apply
>> # save