Setting the Date and Time Chapter 8
WinLink™ 1000 User Manual Release 1.9 8-13
¾ To set the date and time
1. Determine the IP address of the NTP server to be used.
2. Test it for connectivity using the command (Windows XP), for example:
w32tm /stripchart /computer:216.218.192.202
You should get a continuous response of times, each a few seconds
apart.
3. Choose a site to configure.
The Configuration dialog box opens.
4. Choose Date & Time:
Figure 8-10: Date and Time Configuration
5. If entering an IP address for the NTP Server, click Clear, and then enter
the new address.
6. Set your site Offset value in minutes ahead or behind GMT
1
.
7. To manually set the date and time, click Change and edit the new values.
Figure 8-11: Change Date and Time
If you used an NTP Server, you will see a window like this:
1. Greenwich Mean Time
To Next Page
Loading...
