Radwin WinLink 1000 Series - Additional Tools and Materials Required; BDU Package Contents; Cables and Connectors; External Antenna Package Contents

BDU Package Contents Chapter 3
WinLink™ 1000 User Manual Release 1.9 3-6
BDU Package Contents
Figure 3-9: RADWIN BDU
•BDU
• 19” rack mounting kit - see Figure 3-7
• DC power plug for power cable
External Antenna Package Contents
•Antenna
• RF cable 1m (3’) long; two cables supplied with bipolar antennas,
single cable supplied with monopolar antennas
• Mounting kit
Additional Tools and Materials Required
The following is a list of the equipment and materials required to install
WinLink™ 1000 hardware.
Tools and Materials
• Crimping tool for RJ-45 (if the ODU-IDU cable is without connectors)
• Spanner/wrench 13 mm (½”)
• Drill (for wall mounting only)
•Cable ties
• Sealing material
Cables and connectors
• ODU grounding cable 12AWG
• IDU grounding cable 18AWG
• ODU-IDU cable (outdoor class, CAT-5e, 4 twisted pairs, 24AWG)
• For PoE based links: A crossed Ethernet LAN cable
• O-PoE 10AWG grounding cable if applicable
• BDU grounding cable 18AWG if applicable
Hardware Installation Sequence
The following steps are required to install the WinLink™ 1000 system: