Radwin WinLink 1000 Series - Figure 3-10: Typical Installation Diagram (with External Antenna)

Hardware Installation Sequence Chapter 3
WinLink™ 1000 User Manual Release 1.9 3-7
1. Mounting the ODUs, page page 3-8.
2. Mounting the external antennas (if used), page page 3-8.
3. Mounting the Lightning Protection devices (if used), page page 3-9.
4. Outdoor connections, page page 3-9.
5. Mounting the IDUs, page page 3-10.
6. Indoor connections, page page 3-14.
7. Aligning the ODUs/antennas, page page 3-15.
See Figure 3-10 below, which illustrates a typical installation of WinLink™
1000 with an external antenna.
Figure 3-10: Typical Installation Diagram (with external antenna)
The installation steps are detailed in the following sections.