WinLink™ 1000 User Manual Release 1.9 7-1
Chapter 7
Configuring the Link
Overview
This chapter describes the link configuration procedure, which is performed
after the installation of both sides of the WinLink™ 1000 link, as set out in
5.
Link configuration uses a Link Configuration wizard to redefine the configu-
ration parameters and fine-tune an operational link. Both sides of the link
are configured simultaneously.
Link configuration allows you to configure link parameters, which do not
lead to sync loss or require a reset. Some may change service performance,
in respect of which, warnings are displayed.
For ease of use, the Link Configuration wizard follows the same pattern as
Link Installation. You should therefore be familiar with the content of 5.
The following parameters are configured using the Link Configuration Wiz-
ard:
• System parameters
• Channel settings
• Transmission power and antenna settings
•Service parameters
The Configuration Wizard has seven steps as shown in Table 7-1 below.
To Next Page
Loading...
