Default Settings Chapter 4
WinLink™ 1000 User Manual Release 1.9 4-11
Default Settings
The default settings of the WinLink™ 1000 configuration parameters are
listed in the second column of Table 4-4 below. The third column shows
the values we use in this manual for illustrative purposes.
Table 4-4: Default Settings
Parameter Default Value Illustrative Value
Factory default band Product dependent 5.820GHz
ODU IP Address 10.0.0.120 192.168.2.101 and 102
Subnet Mask 255.0.0.0 255.255.255.0
Trap destination 0.0.0.0 0.0.0.0
RADWIN Manager log-on
passwords
Observer admin
Operator admin
Installer wireless
Link ID Link EBG_20561334
Link Name Name TPSF_BTT
Site 1 Site A
Site 2 Site B
Location (per site) Location A B
Name (per site) Name John Mary
Contact (per site) Person Local Remote
Link Password wireless-bridge
Rate Adaptive
Ethernet Configuration Auto Detect
Radio Link Failure Actions No action
Bridge or Hub mode Hub Mode, Aging time = 300 sec
Community values
Read-write – netman
Read-only – public
To Next Page
Loading...
