The Monitor Log Chapter 9
WinLink™ 1000 User Manual Release 1.9 9-11
Tx and Rx bytes for Ethernet). For the Air Interface, user defined thresholds
data are collected. Refer to Table 9-3 and Table 9-4 below.
Data is collected and selectively displayed based on three time intervals as
selected by the Interval radio buttons:
• Current (t=0)
• 15 minutes Intervals
• Daily
Table 9-3: Explanation of performance data
Data type Reported Value Explanation
Generic PM Data
UAS – Unavailable
Seconds
Seconds in which the interface was out of service.
ES – Errored Seconds
The number of seconds in which there was at least one error
block. Note that the notation of an error block is different per
interface.
SES – Severe Errored
Seconds
The number of seconds in which the service quality was low
(the quality is different per type of interface and determined by
the BBER threshold per interface).
BBE – Background Block
Error
The number of errored blocks in an interval.
Integrity
A flag indicating that the data was valid. Note that the
Performance Monitoring data is not valid if not all the values
were stored (e.g., due to clock changes within the interval or
power up reset).
Additional Air Interface
PM Data
Max RSL The maximum of the receive signal level (measured in dBm).
Min RSL The minimum of the receive signal level (measured in dBm).
Max TSL The maximum of the transmit signal level (measured in dBm).
Min TSL The minimum of the transmit signal level (measured in dBm).
RSL Threshold 1
The number of seconds in which the Receive Signal Level (RSL)
was below the specified threshold.
RSL Threshold 2
The number of seconds in which the RSL was below the
specified threshold.
TSL Threshold
The number of seconds in which the Transmit Signal Level
(TSL) was above the specified threshold.
BBER Threshold
The number of seconds in which the Background Block Error
Ratio (BBER) exceeded the specified threshold.
Additional Ethernet
Interface PM Data
Received Bytes
The number of Megabytes received at the specified port within
the interval
Transmitted Bytes
The number of Megabytes transmitted at the specified port
within the interval.
Throughput threshold Seconds count when throughput fell below the threshold
Traffic threshold Seconds count when actual traffic exceeded the threshold
TDM interface
Active seconds
The number of seconds that the configured TDM services are
active
To Next Page
Loading...
