Muting the alignment tone buzzer Chapter 8
WinLink™ 1000 User Manual Release 1.9 8-21
The Configuration dialog box opens.
2. Click Restore.
3. From the Open dialog box choose file to upload and click OK.
Muting the alignment tone buzzer
The ODU alignment tone becomes audible as soon as power is supplied,
and continues until the ODUs are aligned and the link established.
It is possible to mute the tone during regular operation of the link. It must
be enabled when performing the alignment procedure.
¾ To mute the alignment tone buzzer:
1. Choose a site. The Configuration dialog box opens.
2. In the Configuration dialog box, click the Buzzer button.
Figure 8-19: Alignment tone buzzer states
3. Click Off. The tone is disabled.
¾ To restore the alignment tone buzzer:
1. Choose a site. The Configuration dialog box opens.
2. Click On to have the buzzer beep continuously or Auto to have the
buzzer beep only in install mode.
Configuration with Telnet
A Telnet terminal can be used to configure and monitor the WinLink™ 1000.
To start a Telnet session, use telnet <ODU_IP>.
For example, if you run Telnet as follows,
telnet 192.168.2.101
you will be asked for a user name and password.
Caution
Backup files are specific to a site (IDU / ODU pair and Link ID).
Do not restore a backup configuration file to a site other than that from
which it was originally taken.
To Next Page
Loading...
