EasyManua.ls Logo

Radwin WinLink 1000 Series - Trap Parameters

Radwin WinLink 1000 Series
280 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Trap Parameters Appendix Q
WinLink™ 1000 User Manual Release 1.9 Q-19
Trap Parameters
Table Q-3: MIB Traps (Sheet 1 of 4)
Name ID Severity Description
trunkStateChanged 1 normal Indicates a change in the state of one of the TDM trunks.Raised by both
sides of the link.Contains 3 parameters:1 - Description: TDM Interface %n
- %x2 - %n: Is the trunk number3 - %x: Is the alarm type and can be one
of the following: Normal, AIS, LOS, Loopback
linkUp 2 normal Indicates that the radio link is up.Contains a single parameter, which is its
description:1 - Description: Radio Link - Sync on channel %n GHz.%n Is
the channel frequency in GHz.
linkDown 3 critical Indicates that the radio link is down.Contains a single parameter, which is
its description:1 - Description: Radio Link - Out of Sync. The reason is:
%s.%s Is the reason.
detectIDU 4 normal Indicates that the IDU was detected.Raised by both sides of the
link.Contains a single parameter, which is its description:1 - Description:
IDU of Type %s was Detected.%s Is the type of the IDU.
disconnectIDU 5 major Indicates that the IDU was disconnected.Raised by both sides of the
link.Contains a single parameter, which is its description:1 - Description:
IDU Disconnected.
mismatchIDU 6 major Indicates a mismatch between the IDUs.Raised by the master
only.Contains a single parameter, which is its description:1 - Description:
IDUs Mismatch: One Side is %s and the Other is %s.%s Is the type of the
IDU.
openedServices 7 normal Indicates that services were opened. Raised by the master only.Contains
3 parameters:1 - Description: %n2 out of %n1 Requested TDM Trunks
have been Opened2 - %n1: Is the requested number of TDM truncks3 -
%n2: Is the actual number of TDM trunks that were opened
closedServices 8 normal Indicates that services were closed.Raised by the master only.Contains
a single parameter, which is its description:1 - Description: TDM Service
has been closed. The reason is: %s.%s Is the reason.
incompatibleODUs 9 critical Indicates that the ODUs are incompatible.Contains a single parameter,
which is its description:1 - Description: Incompatible ODUs.
incompatibleIDUs 10 major Indicates that the IDUs are incompatible.Contains a single parameter,
which is its description:1 - Description: Incompatible IDUs.
incompatibleOduIdu 11 major Indicates that the ODU and IDU are incompatible.Contains a single
parameter, which is its description:1 - Description: The IDU could not be
loaded. The reason is: %s.%s Is the incompatibility type.
probingChannel 12 normal Indicates that the ODU is monitoring radar activity.Contains a single
parameter, which is its description:1 - Description: Monitoring for radar
activity on channel %n GHz.%n is the channel frequency in GHz.
radarDetected 13 normal Indicates that radar activity was detected.Contains a single parameter,
which is its description:1 - Description: Radar activity was detected in %s,
on channel %n GHz.%s Is the site name.%n Is the channel frequency in
GHz.
transmittingOnChannel 14 normal Indicates that the ODU is transmitting on channel.Contains a single
parameter, which is its description:1 - Description: Transmitting on
channel %n GHz.%n Is the channel frequency in GHz.
scanningChannels 15 normal Indicates that the ODU is scanning channels.Contains a single
parameter, which is its description:1 - Description: Channel scanning in
progress.
incompatiblePartner 16 critical Indicates that configuration problem was detected and that link
installation is required in order to fix it.Contains a single parameter, which
is its description:1 - Description: Configuration problem detected. Link
installation required.
timeClockSet 17 normal Indicates that the ODU time clock was set.Contains a single parameter,
which is its description:1 - Description: The time was set to: %p.%p Is the
date and time.
configurationChanged 18 normal Indicates that the ODU recovered from an error, but there are
configuration changes.Contains two parameters:1 - Description:
Configuration changed. Error code is: %n.2 - %n number.

Table of Contents

Related product manuals