Trap Parameters Appendix Q
WinLink™ 1000 User Manual Release 1.9 Q-20
hssOpStateChangedToINU 19 normal Indicates that the HSS operating state was changed to INU
type.Contains a single parameter, which is its description:1 - Description:
HSS operating state was changed to: INU.
hssOpStateChangedToHSM 20 normal Indicates that the HSS operating state was changed to HSM
type.Contains a single parameter, which is its description:1 - Description:
HSS operating state was changed to: HSM.
hssOpStateChangedToHSC 21 normal Indicates that the HSS operating state was changed to HSC
type.Contains a single parameter, which is its description:1 - Description:
HSS operating state was changed to: HSC_DT/HSC_CT.
vlanModeActive 22 normal Indicates to non-VLAN PC that after 2 minutes the system will support
only VLANtag on management interface. Contains a single parameter,
which is its description:1 - Description: VLAN Mode is active. Non-VLAN
traffic will be blocked in 2 minutes.
tdmServiceAlarm 100 major Indicates that TDM Service is in alarm state.Contains a single parameter,
which is its description:1 - Description: TDM Service - Alarm.
ethServiceClosed 101 major Indicates that Ethernet Service is closed.Contains a single parameter,
which is its description:1 - Description: Ethernet Service is closed.
ethServiceNotPermitted 102 major Indicates that Ethernet Service is not permitted.Contains a single
parameter, which is its description:1 - Description: A valid IDU could not
be detected at %s. Please check your configuration.%s - Is the Local Site
name or Remote Site name or both sides of the Link.
encryptionAlarm 103 major Indicates an encryption key mismatch.Contains a single parameter,
which is its description:1 - Description: Encryption Status - Failed. No
Services are available.
changeLinkPasswordAlarm 104 major Indicates that a failure has occurred while attempting to change the Link
Password.Contains a single parameter, which is its description:1 -
Description: Failed to change the Link Password at/on: %s.%s - Is the
Local Site name or Remote Site name or both sides of the Link.
externalAlarmInPort1Alarm 105 major The trap is sent every time an alarm occurs in the External Alarm Input of
port #1.Contains a single parameter, which is its description:1 -
Description: External Alarm 1 - <User Text> - Alarm.
externalAlarmInPort2Alarm 106 major The trap is sent every time an alarm occurs in the External Alarm Input of
port #2.Contains a single parameter, which is its description:1 -
Description: External Alarm 2 - <User Text> - Alarm.
bitFailedAlarm 107 critical The trap is sent if there is no way to recover from the situation.Contains
two parameters:1 - Description: ODU power up built in test failed. Error
code is: %n2 - %n number
wrongConfigurationLoadedAlarm 108 major The trap is sent if there is a way to recover from the situation.Contains
two parameters:1 - Description: Wrong configuration loaded. Error code
is: %n2 - %n number
lanPort1DisconnectedAlarm 109 major Indicates the LAN port 1 status changed to disconnected.Contains a
single parameter, which is its description:1 - Description: LAN port 1
status changed to disconnected.
lanPort2DisconnectedAlarm 110 major Indicates the LAN port 2 status changed to disconnected.Contains a
single parameter, which is its description:1 - Description: LAN port 2
status changed to disconnected.
mngPortDisconnectedAlarm 111 major Indicates the management port status changed to
disconnected.Contains a single parameter, which is its description:1 -
Description: Management port status changed to disconnected.
externalAlarmInPort3Alarm 112 major The trap is sent every time an alarm occurs in the External Alarm Input of
port #3.Contains a single parameter, which is its description:1 -
Description: External Alarm 3 - <User Text> - Alarm.
externalAlarmInPort4Alarm 113 major The trap is sent every time an alarm occurs in the External Alarm Input of
port #4.Contains a single parameter, which is its description:1 -
Description: External Alarm 4 - <User Text> - Alarm.
swVersionsMismatchFullCompatibilityAlarm 114 warning The trap is sent if SW versions mismatch with full link
functionality.Contains a single parameter, which is its description:1 -
Description: Software versions mismatch - full link functionality
Table Q-3: MIB Traps (Sheet 2 of 4)
Name ID Severity Description
To Next Page
Loading...
