WinLink™ 1000 Link Chapter 1
WinLink™ 1000 User Manual Release 1.9 1-6
mutual interference commonly experienced with collocated TDD
radios.
» Monitored Hot Standby (1+1):
The RADWIN Monitored Hot Standby supports equipment and air-
interface redundancy with less than 50 ms cut-over time for carriers
and operators.
» Enhanced Air Interface Security
WinLink™ 1000's AES 128-bit key encryption provides enhanced air
interface security.
» Advanced Management and Performance Monitoring
The WinLink™ 1000 Manager software has full local and remote
management capabilities. The user-friendly SNMP based manage-
ment tool provides full end to end configuration, event log, and per-
formance monitoring capabilities.
Multiple WinLink™ 1000 links can be managed by RADWIN Network
Management System (RNMS).
» SFP support in the IDU-C
Standard SFP modules are used, enabling any type of Ethernet phys-
ical connectivity including various fiber connections. E3/T3 or E1/T1
over Ethernet SFPs can be used as well.
WinLink™ 1000 Link
The WinLink™ 1000 point-to-point solution is a wireless communication link.
Typically each side of the link is comprised of an Outdoor Unit (ODU) and
antenna and an Indoor Unit (IDU) or PoE device as shown in Figure 1-7
below.
The link is managed by the SNMP-based RADWIN Manager application.
The IDU and the ODU are connected by a CAT5e cable that carries the ser-
vice traffic and power.
Figure 1-7: Example of Link Architecture - System Components
To Next Page
Loading...
Need help?
General
