Mounting the IDU-C Chapter 3
WinLink™ 1000 User Manual Release 1.9 3-10
Figure 3-11: Typical IDU-E Rear Panel
IDU-R Installation
Figure 3-12: IDU-R Rear Panel
Installation of an IDU-R unit differs from other IDU models in one respect:
At the rear of the IDU-R (see Figure 3-12) there are two jacks labeled
“Trunks”. For each IDU-R, the E1 cable from outside should be plugged into
one of the trunks, and the E1 cable to the other station should be plugged
into the second trunk, as in the left hand side of Figure 1-14.
Apart from the above difference, the link installation including the remaining
part of the IDU installation and connection to the ODU proceeds as
described as above.
Mounting the IDU-C
The WinLink™ 1000 IDU-Cs are all rack mountable, as shown in Figure 3-
13. A front panel keyed schematic of a rack mounted IDU-C is shown in the
figure below.
Figure 3-13: IDU-C front panel
In Figure 3-14 we display a perspective view of the IDU-C:
To Next Page
Loading...
