Radwin WinLink 1000 Series User Manual

WinLink™ 1000 User Manual Release 1.9 E-1
Appendix E
Changing the Factory
Default Band
Why this is Needed
All ODUs supplied by RADWIN come with pre-configured with a factory
default product-dependent band according to the ODU part number.
For ODUs supporting Multi-band, it may be changed using the procedure in
this appendix. The procedure is generic, applying to all ODUs with the Multi-
band feature.
Required Equipment
The minimal equipment required to change an ODU default band is:
• Laptop computer (managing computer) satisfying the requirements
of Table 4-1.
• An installed copy of the RADWIN Manager
• A PoE device
• A crossed Ethernet LAN cable
• An IDU-ODU cable
The procedure
Caution
• If for some reason the default band needs to be changed, it should
be done before link installation.
• Use of an incorrect band may be in violation of local regulations.
Note
The following procedure is generic to all relevant RADWIN radio products.
What you see on your running RADWIN Manager may differ in some details
from the screen captures used to illustrate this Appendix.

Radwin WinLink 1000 Series Specifications

General

Brand	Radwin
Model	WinLink 1000 Series
Category	Network Hardware
Language	English