EasyManua.ls Logo

Radwin WinLink 1000 Series - Configuration; TDM Interface; Figure 7-11 Configuration

Radwin WinLink 1000 Series
280 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuration Appendix N
WinLink™ 1000 User Manual Release 1.9 N-2
Configuration
TDM Interface
Channel Bandwidth 5MHz for Access, all ther models 5MHz, 10MHz and 20MHz (5MHz Resolution)
Radio Modulation OFDM (BPSK/QPSK/16QAM/64QAM)
Adaptive Modulation & Coding Supported
Automatic Channel Selection Supported
Duplex Technology TDD
Error Correction FEC k = 1/2, 2/3, 3/4
Rate [Mbps] 6 9 12 18 24 26 48 54
Modulation BPSK QPSK 16QAM 64QAM
FEC [k=] 1/2 3/4 1/2 3/4 1/2 3/4 2/3 3/4
Max Tx Power [dBm] 23 20 16
Sensitivity (dBm) @BER <10e-11 (20MHz) -87 -84 -80 -79 -73 -66 -62
Encryption AES 128
Architecture
ODU: Outdoor Unit with Integrated Antenna or Connectorized for External
Antenna
IDU: Indoor Unit for service interfaces or PoE device for Ethernet only
IDU to ODU Interface Outdoor CAT-5e cable; Maximum cable length: 100m
Number of Ports 0, 1, 2 and 4 depending on IDU model
Type E1/T1 configurable, IDU-C, E1 or T1 factory preset, IDU-E.
Framing Unframed (transparent)
Timing Independent timing per port, Tx and Rx, IDU-C
Connector RJ-45
Standards Compliance ITU-T G.703, G.826
Line Code E1: HDB3 @ 2.048 Mbps, T1: B8ZS/AMI @ 1.544 Mbps
Latency Configurable 5-20 ms
Impedance E1: 120, balanced, T1: 100, balanced
Jitter & Wander According to ITU-T G.823, G.824

Table of Contents

Related product manuals