Installation Chapter 5
WinLink™ 1000 User Manual Release 1.9 5-15
3. You may make any further changes to the Service Configuration
or the Jitter buffer. When you are satisfied, click the Evaluate.
The optimum transmission rate for the selected services is evaluated.
Following a short delay for processing, Back and Next are
enabled.
4. Click Next to continue.
Step 6, TDM Clock Configuration
The following dialog is displayed:
Figure 5-18: TDM Parameters Configuration (1)
¾ To configure TDM clock parameters:
1. For any individual port, click it. For the same parameters for all
ports, click the Select All tag.
2. Click Configure. The following drop down list is displayed:
Note
The transmission rates used by WinLink™ 1000 are shown in Table 5-4
above.
Note
• Select Maximum will select the maximum number of services that
can be carried by the air interface
• Select All unconditionally selects all of the services
To Next Page
Loading...
