WinLink™ 1000 User Manual Release 1.9 I-1
Appendix I
BRS Installation
Procedure
BRS Link Activation
In accordance with 2.5 GHz standard, WinLink™ 1000-BRS links must be
activated before use. This is done at both ODUs independently before
installation on site. Both ODUs must be configured the same.
¾ To Activate a BRS Link:
1. Install RADWIN Manager software as usual.
2. When the Manager Main Screen is displayed it appears with the Link Sta-
tus label red and showing Inactive. The Link Configuration and Link
installation buttons are disabled.
Figure I-1: Inactive link state
3. Click Configuration>Configure Location
The Air Interface dialog box opens:
To Next Page
Loading...
