Installing a RADWIN MHS Appendix K
WinLink™ 1000 User Manual Release 1.9 K-6
Figure K-5: Services Configuration Panel: Hot Standby mode selection
Check the Primary button to configure Primary Link as the primary link.
8. Complete the Wizard, and then move to Secondary Link.
9. Repeat step 8 for Secondary Link. For the Services Hot Standby tab, this
time, check the Secondary button.
10. Complete the Wizard.
11. At Site 1.2, reconnect the Hot Standby Patch panel to the external
equipment.
From this point on, we will simply refer to primary and secondary link (no
capitalized names).
At the end of the process, the RADWIN Manager main windows should look
like this:
To Next Page
Loading...
