WinLink™ 1000 User Manual Release 1.9 Q-1
Appendix Q
MIB Reference
Introduction
About the MIB
The RADWIN MIB is a set of APIs that enables external applications to con-
trol RADWIN equipment.
The MIB is divided into public and a private API groups:
• Public: RFC-1213 (MIB II) variables, RFC-1214 (MIB II) System and
Interfaces sections
• Private: Controlled by RADWIN and supplements the public group.
This appendix describes the public and private MIB used by RADWIN.
Terminology
The following terms are used in this appendix.
In addition, the MIB uses internally, the older notions of Local site and
Remote site where this manual would use site A and site B.
To avoid burdening the reader, this appendix will follow the MIB usage.
Interface API
Control Method
The RADWIN Manager application provides all the means to configure and
monitor a WinLink™ 1000 link, communicating with the SNMP agent in each
ODU. Each SNMP agent contains data on each of the IDUs and ODUs in the
Term Meaning
MIB Management Information Base
API Application Programming Interface
SNMP Simple Network Management Protocol
To Next Page
Loading...
Need help?
General
