Upgrading an Installed Link Appendix F
WinLink™ 1000 User Manual Release 1.9 F-3
As an alternative to adding sites one at a time, you can add sites from a
prepared list using the Add from File option in Figure F-2. The list has
the following format:
<IP address>,<Read-Only community>,<Read-Write community>
Here is an example:
192.168.1.101,public,netman
192.168.1.102,public,netman
192.168.2.101,public,netman
192.168.2.102,public,netman
3. Having created an update list, click Upgrade Package to chose the rel-
evant files. The default files are located in the SWU subdirectory in the
RADWIN Manager installation area. They are currently named
SWU_1k.swu and SWU_2k.swu. You may have to find them else-
where, depending on your system.
4. To back up your existing system, check Backup device software. Then
click the button for a standard file dialog. The default location is
the My Documents directory on the managing computer.
5. The next check box determines whether or not the sites should be reset
immediately after the upgrade. Bear in mind that on the one hand, a
reset involves a service interruption, but on the other hand, the software
upgrade will not become effective until after the reset is carried out.
6. Click Start Upgrade to commence the process.
Figure F-5: Software upgrade in progress - Note the stop button
7. Click Close to exit.
Note
The backup here is the same as that in page 8-28, and serves the same
purpose. It provides a fallback if the upgrade proves problematic.
To Next Page
Loading...
