Radwin WinLink 1000 Series User Manual

Getting Started with the RADWIN Manager Chapter 4
WinLink™ 1000 User Manual Release 1.9 4-2
2. Choose Install RADWIN Manager and follow the on-screen instructions
of the installation wizard to complete the setup of the RADWIN Manager
application.
If the installation program fails to start, browse to your CD/DVD drive,
chose the setup.exe program and run it.
Getting Started with the RADWIN Manager
If your links are within easy reach, you can configure them using the proce-
dure described below. If however, your links are to be geographically scat-
tered, it may be convenient to pre-load each ODU with its network address
prior to physical installation. The procedure is quite straight forward, and
set out in Appendix D.
¾ To start the RADWIN Manager:
1. Connect the managing computer to one of the two LAN ports as shown in
Figure 4-1 below:
Figure 4-1: LAN ports on the front panel of the IDU-C
Note
Each ODU requires a static IP address, since part of the link definition is the
IP address pair of both ODUs. Network Managers should ensure that these
addresses are outside of the automatic allocation ranges used by their
network DHCP server.

Radwin WinLink 1000 Series Specifications

General

Brand	Radwin
Model	WinLink 1000 Series
Category	Network Hardware
Language	English