Common Measurement Settings
R&S
®
FSPN
142User Manual 1179.4363.02 ─ 01
6.9.10 Limit Lines
Access: "Overview" > "Analysis" > "Limit Lines"
You can use limit lines in the diagrams of the transient analysis. The basic principle of
limit lines is the same as in other phase noise measurement only with a different scale
(time on the x-axis and frequency or phase on the y-axis). Relative limits in the fre-
quency diagram always refer to current center frequency you have defined for the tran-
sient measurement. Relative limits in the phase diagram always refer to the reference
value.
For more information about configuring and using limit lines, see Chapter 7.5, "Limit
Lines", on page 174.
PN Transient Analysis Configuration
To Next Page
Loading...
