R&S FSPN - How to Define Limit Lines

Common Analysis and Display Functions
R&S
®
FSPN
181User Manual 1179.4363.02 ─ 01
Data Points
Each limit line is defined by a minimum of 2 and a maximum of 200 data points. Each
data point is defined by its position (x-axis) and value (y-value). Data points must be
defined in ascending order. The same position can have two different values.
Remote command:
CALCulate<n>:LIMit<li>:CONTrol[:DATA] on page 443
CALCulate<n>:LIMit<li>:LOWer[:DATA] on page 445
CALCulate<n>:LIMit<li>:UPPer[:DATA] on page 447
Insert Value
Inserts a data point in the limit line above the selected one in the "Edit Limit Line" dia-
log box.
Delete Value
Deletes the selected data point in the "Edit Limit Line" dialog box.
Shift x
Shifts the x-value of each data point horizontally by the defined shift width.
Remote command:
CALCulate<n>:LIMit<li>:CONTrol:SHIFt on page 444
Shift y
Shifts the y-value of each data point vertically by the defined shift width.
Remote command:
CALCulate<n>:LIMit<li>:LOWer:SHIFt on page 445
CALCulate<n>:LIMit<li>:UPPer:SHIFt on page 447
Save
Saves the currently edited limit line under the name defined in the "Name" field.
7.5.3 How to Define Limit Lines
Access: "Overview" > "Analysis" > "Lines" > "Limit Lines"
The following tasks are described here:
●
"How to find compatible limit lines" on page 181
●
"How to activate and deactivate a limit check" on page 182
●
"How to edit existing limit lines" on page 182
●
"How to copy an existing limit line" on page 182
●
"How to delete an existing limit line" on page 182
●
"How to configure a new limit line" on page 183
●
"How to move the limit line vertically or horizontally" on page 184
How to find compatible limit lines
► In the "Line Config" dialog box, select the "View Filter" option: "Show Compatible" .
Limit Lines