R&S FSPN - Common Measurement Settings; Remote Commands to Configure the Input Source

Remote Control
R&S
®
FSPN
337User Manual 1179.4363.02 ─ 01
// Turn on marker 1 in window 1
CALC1:MARK1:STAT ON
// Set marker 1 stimulus
CALC1:MARK1:X 300 kHz
// Query marker 1 result
CALC1:MARK1:Y?
11.6 Common Measurement Settings
● Remote Commands to Configure the Input Source.............................................. 337
● Output................................................................................................................... 339
● Remote Commands to Configure User Ports........................................................348
● Remote Commands to Configure Level Characteristics....................................... 350
● Remote Commands to Configure the Frequency..................................................356
● Phase Noise Measurement Configuration............................................................ 360
● VCO Characterization Configuration.....................................................................379
● Spot Noise vs Tune Configuration........................................................................ 382
● Transient Analysis.................................................................................................386
11.6.1 Remote Commands to Configure the Input Source
● RF Input................................................................................................................ 337
11.6.1.1 RF Input
INPut<ip>:COUPling.......................................................................................................337
INPut<ip>:SELect...........................................................................................................338
INPut<1|2>:LOSCillator:SOURce.....................................................................................338
INPut<1|2>:LOSCillator:SOURce:EXTernal:LEVel............................................................. 338
INPut<ip>:COUPling <CouplingType>
This command selects the coupling type of the RF input.
Suffix:
<ip>
.
1 | 2
irrelevant
Parameters:
<CouplingType> AC | DC
AC
AC coupling
DC
DC coupling
*RST: AC
Example:
INP:COUP DC
Common Measurement Settings