R&S FSPN - Output

Remote Control
R&S
®
FSPN
339User Manual 1179.4363.02 ─ 01
LOW
LO signal with low level characteristics.
*RST: HIGH
Example: //Select an external LO with low signal level
CONF:PNO:MEAS RES
INP:LOSC:SOUR EXT
INP:LOSC:SOUR:EXT:LEV LOW
Manual operation: See "Local Oscillator" on page 100
11.6.2 Output
● DC Power..............................................................................................................339
11.6.2.1 DC Power
SOURce:CURRent:AUX:LIMit:HIGH?.............................................................................. 339
SOURce:CURRent:CONTrol<i>:LIMit:HIGH?....................................................................340
SOURce:CURRent:POWer<i>:LIMit:HIGH........................................................................340
SOURce:CURRent:SEQuence:RESult?........................................................................... 340
SOURce:POWer:SEQuence:RESult?...............................................................................341
SOURce:VOLTage:AUX:LEVel:AMPLitude........................................................................341
SOURce:VOLTage:AUX:LEVel:LIMit:HIGH....................................................................... 341
SOURce:VOLTage:AUX:LEVel:LIMit:LOW........................................................................ 342
SOURce:VOLTage:AUX:LEVel[:STATe]............................................................................ 342
SOURce:VOLTage:CHANnel:COUPling............................................................................342
SOURce:VOLTage:CONTrol<i>:LEVel:AMPLitude............................................................. 343
SOURce:VOLTage:CONTrol<i>:LEVel:LIMit:HIGH.............................................................343
SOURce:VOLTage:CONTrol<i>:LEVel:LIMit:LOW..............................................................343
SOURce:VOLTage:CONTrol<i>:LEVel[:STATe]..................................................................344
SOURce:VOLTage:POWer<i>:LEVel:AMPLitude............................................................... 344
SOURce:VOLTage:POWer<i>:LEVel:LIMit:HIGH............................................................... 345
SOURce:VOLTage:POWer<i>:LEVel:LIMit:LOW................................................................345
SOURce:VOLTage:POWer<i>:LEVel:MODE..................................................................... 346
SOURce:VOLTage:POWer<i>:LEVel[:STATe].................................................................... 346
SOURce:VOLTage:POWer<i>:LIMit:HIGH........................................................................ 347
SOURce:VOLTage:SEQuence:RESult?............................................................................347
SOURce:VOLTage[:STATe]............................................................................................. 348
SOURce:CURRent:AUX:LIMit:HIGH?
This command returns the maximum current of the V
aux
connector.
Return values:
<Current> <numeric value>
The return value is always 0.1 A.
Common Measurement Settings