R&S FSPN - Page 344

Remote Control
R&S
®
FSPN
344User Manual 1179.4363.02 ─ 01
Parameters:
<Voltage> <numeric value>
Range: -10 to 28
*RST: 0
Default unit: V
Example: //Define a minimum voltage of -5 V
SOUR:VOLT:CONT:LEV:LIM:LOW -5
Manual operation: See "Defining the output level" on page 125
SOURce:VOLTage:CONTrol<i>:LEVel[:STATe]
<State>
This command turns the tuning voltage source (V
tune
) on and off.
Note that DC power is actually supplied only if you additionally activate the outputs in
general.
Prerequisites for this command
●
Turn on DC power sources (SOURce:VOLTage[:STATe]).
Suffix:
<i>
.
1..n
irrelevant
Parameters:
<State> ON | OFF | 1 | 0
*RST: OFF
Example: //Turn on the V
tune
voltage source
SOUR:VOLT:CONT:LEV ON
Manual operation: See "Turning the output on and off" on page 124
SOURce:VOLTage:POWer<i>:LEVel:AMPLitude <Voltage/Current>
This command defines the output voltage for the V
supply
source.
Suffix:
<i>
.
1..n
irrelevant
Common Measurement Settings