Remote Control
R&S
®
FSPN
312User Manual 1179.4363.02 ─ 01
11.2 Common Suffixes
In the application, the following common suffixes are used in remote commands:
Table 11-1: Common suffixes used in remote commands in the application
Suffix Value range Description
<m> 1 to 16 Marker
<n> 1 to 16 Window (in the currently selected channel)
<t> 1 to 6 Trace
<li> 1 to 8 Limit line
11.3 Common Commands
*CAL?...........................................................................................................................312
*CLS.............................................................................................................................313
*ESE.............................................................................................................................313
*ESR?...........................................................................................................................313
*IDN?............................................................................................................................313
*IST?............................................................................................................................ 313
*OPC............................................................................................................................314
*OPT?...........................................................................................................................314
*PCB............................................................................................................................ 314
*PRE............................................................................................................................ 314
*PSC............................................................................................................................ 314
*RST.............................................................................................................................315
*SRE............................................................................................................................ 315
*STB?...........................................................................................................................315
*TRG............................................................................................................................ 315
*TST?...........................................................................................................................316
*WAI.............................................................................................................................316
*CAL?
Calibration query
Initiates a calibration of the instrument and then queries the calibration status. Respon-
ses > 0 indicate errors.
Note: If you start a self-alignment remotely, then select the "Local" softkey while the
alignment is still running, the instrument only returns to the manual operation state
after the alignment is completed.
Usage:
Query only
Manual operation: See " Start Self Alignment " on page 213
Common Commands
To Next Page
Loading...
