R&S FSPN - Transient Analysis

Remote Control
R&S
®
FSPN
386User Manual 1179.4363.02 ─ 01
Example: //Remove spurs
SPUR:SUPP ON
Manual operation: See "Hiding spurs" on page 120
[SENSe:]SPURs:THReshold <Threshold>
This command defines a level threshold for spur removal.
Prerequisites for this command
●
Select Spot Noise vs Tune measurement (CONFigure:SNTune:MEASurement[:
STATe]).
●
Turn on spur removal (DISPlay[:WINDow<n>]:TRACe<t>:SPURs:THReshold
).
The threshold applies to all traces. If you need to define a threshold for each trace sep-
arately (possible in all measurements except Spot Noise vs Tune), use DISPlay[:
WINDow<n>]:TRACe<t>:SPURs:THReshold.
Parameters:
<Threshold> <numeric value>
*RST: 0
Default unit: dB
Example: //Remove spurs
SPUR:SUPP ON
SPUR:THR 5
Manual operation: See "Hiding spurs" on page 120
11.6.9 Transient Analysis
● Frequency Configuration.......................................................................................386
● Amplitude Configuration........................................................................................389
● Data Acquisition.................................................................................................... 390
● Trigger Configuration............................................................................................ 391
● Y-Axis Scale.......................................................................................................... 394
● Settling Time......................................................................................................... 398
● Frequency Deviation............................................................................................. 399
● Trace Configuration...............................................................................................401
● Marker Configuration.............................................................................................402
● Limit Lines.............................................................................................................402
11.6.9.1 Frequency Configuration
Commands to configure the frequency described elsewhere.
●
Center frequency: [SENSe:]FREQuency:CENTer
●
Start frequency: [SENSe:]FREQuency:STARt
Common Measurement Settings