R&S FSPN - Page 399

Remote Control
R&S
®
FSPN
399User Manual 1179.4363.02 ─ 01
Example:
CALC:SETT:TIME:TRAC Trace1
CALCulate<n>:SETTling:TIME:FREQuency:LIMit:LOWer <Frequency>
This command defines the lower frequency of settling time measurement.
Suffix:
<n>
.
irrelevant
Parameters:
<Frequency> Default unit: Hz
Example:
CALC1:SETT:TIME:LOW:FREQ:LIM 100
CALCulate<n>:SETTling:TIME:FREQuency:LIMit:UPPer <Frequency>
This command defines the upper frequency of settling time measurement.
Suffix:
<n>
.
irrelevant
Parameters:
<Frequency> Default unit: Hz
Example:
CALC1:SETT:TIME:UPP:FREQ:LIM 1000
CALCulate<n>:SETTling:TIME:RESult?
This command returns the settling time.
Suffix:
<n>
.
irrelevant
Example:
CALC1:SETT:TIME:RES?
Usage: Query only
11.6.9.7 Frequency Deviation
CALCulate<n>:FREQuency:DEViation:STATe...................................................................399
CALCulate<n>:FREQuency:DEViation:DIAGram...............................................................400
CALCulate<n>:FREQuency:DEViation:TRACe..................................................................400
CALCulate<n>:FREQuency:DEViation:STARt...................................................................400
CALCulate<n>:FREQuency:DEViation:STOP....................................................................400
CALCulate<n>:FREQuency:DEViation:REGRession?........................................................401
CALCulate<n>:FREQuency:DEViation:REGRession:POINts?............................................ 401
CALCulate<n>:FREQuency:DEViation:SLOPe?................................................................401
CALCulate<n>:FREQuency:DEViation:STATe <State>
This command defines the state of frequency deviation measurement.
Common Measurement Settings