R&S FSPN - Programming Examples; Trace<N>[:Data]:Y; Trace<N>[:Data]:Y:points

Remote Control
R&S
®
FSPN
336User Manual 1179.4363.02 ─ 01
TRACe<n>[:DATA]:Y? <Trace>
Queries Y trace values merged with spurs for a given window and trace.
Suffix:
<n>
.
1..n
Window
Query parameters:
<Trace> TRACe1 | TRACe2 | TRACe3 | TRACe4 | TRACe5 | TRACe6
Return values:
<Result> Comma separated list of Y values
Usage: Query only
Manual operation: See "Noise Diagram" on page 88
TRACe<n>[:DATA]:Y:POINts?
<Trace>
Queries number of points of trace data merged with spurs.
Suffix:
<n>
.
1..n
Window
Query parameters:
<Trace> TRACe1 | TRACe2 | TRACe3 | TRACe4 | TRACe5 | TRACe6
Return values:
<Points> <numeric value> (integer)
Usage: Query only
Manual operation: See "Noise Diagram" on page 88
11.5.4 Programming Examples
Performing a phase noise measurement
//Preset
*RST
//Select single sweep mode
INIT:CONT OFF
// Configure start and stop offset
SENS:FREQ:START 1kHz
SENS:FREQ:STOP 1MHZ
// Configure RBW in %
LIST:BWID:RAT 10
// Configure cross correllation factor
SWE:XFAC 1
// Start synchronized measurement
INIT:IMM;*OPC?
Measurements and Result Displays