Network and Remote Operation
R&S
®
FSPN
286User Manual 1179.4363.02 ─ 01
Note that aside from the "Language" feature (and for PSA compatibility, the "Wide-
band" feature), all other functions in this dialog are currently not supported.
Language.................................................................................................................... 286
Wideband....................................................................................................................286
Language
Defines the system language used to control the instrument.
The following languages are supported.
●
SCPI
●
5052
For a list of supported commands, see Chapter 11.9.9, "Reference: Command Set
of 5052 Emulation", on page 509.
●
PSA
For a list of supported commands, see Chapter 11.9.10, "Reference: Command
Set of Emulated PSA Models", on page 511.
The 5052 language is only available in the Phase Noise application. If you select the
5052 mode in an application other than the Phase Noise application, the R&S FSPN
automatically closes all applications and opens one channel with the Phase Noise
application.
The PSA language is only available for the Spectrum application. If you select the PSA
mode in an application other than the Spectrum application, the R&S FSPN automati-
cally closes all applications and opens one channel with the Spectrum application.
Remote command:
SYSTem:LANGuage on page 495
Wideband
This setting defines which option is returned when the *OPT? query is executed,
depending on the state of the wideband option.
It is only available for PSA89600 emulation.
"Off"
No wideband is used.
The option is indicated as "B7J".
"40 MHz"
The 40 MHz wideband is used.
The option is indicated as "B7J, 140".
"80 MHz"
The 80 MHz wideband is used.
The option is indicated as "B7J, 122".
Remote command:
SYSTem:PSA:WIDeband on page 496
10.3.4 LAN Settings
Access: [SETUP] > "Network + Remote" > "LAN" tab
In a LAN network, the R&S FSPN can be accessed via any web browser (e.g. the
Microsoft Internet Explorer) to perform the following tasks:
●
Modifying network configurations
Network and Remote Control Settings
To Next Page
Loading...
