R&S FSPN - Hardware Information; System Configuration Settings

General Instrument Setup
R&S
®
FSPN
230User Manual 1179.4363.02 ─ 01
"Output 640 MHz"
Provides a 640 MHz reference signal to the REF OUTPUT 640 MHz
connector.
"Output Sync Trigger"
Provides a 100 MHz reference signal to the SYNC TRIGGER OUT-
PUT connector.
Remote command:
[SENSe:]ROSCillator:O640 on page 480
[SENSe:]ROSCillator:OSYNc on page 480
Resetting the Default Values
The values for the "Tuning Range", "Frequency" and "Loop Bandwidth" are stored for
each source of "Reference Frequency Input".
When you switch the input source, the previously defined settings are restored. You
can restore the default values for all input sources using the "Preset Channel" function.
9.4 System Configuration Settings
Access: [Setup] > "System Configuration"
● Hardware Information............................................................................................230
● Information on Versions and Options....................................................................231
● System Messages.................................................................................................232
● Firmware Updates.................................................................................................233
● General Configuration Settings.............................................................................235
9.4.1 Hardware Information
Access: [Setup] > "System Configuration" > "Hardware Info"
An overview of the installed hardware in your R&S FSPN is provided.
Every listed component is described by its serial number, order number, model infor-
mation, hardware code, and hardware revision.
This information can be useful when problems occur with the instrument and you
require support from Rohde & Schwarz.
System Configuration Settings