R&S FSPN - Querying Results; Calculate<N>:Snoise<S>[:Trace<T>]:Y? on Page 374

Remote Control
R&S
®
FSPN
327User Manual 1179.4363.02 ─ 01
Manual operation: See " Continuous Sweep / Run Cont " on page 85
INITiate<n>[:IMMediate]
This command starts a (single) new measurement.
With measurement count or average count > 0, this means a restart of the correspond-
ing number of measurements. With trace mode MAXHold, MINHold and AVERage, the
previous results are reset on restarting the measurement.
You can synchronize to the end of the measurement with *OPC, *OPC? or *WAI.
Suffix:
<n>
.
irrelevant
Manual operation: See " Single Sweep / Run Single " on page 85
11.5.3
Querying Results
Commands to query results described elsewhere:
●
CALCulate<n>:SNOise<s>[:TRACe<t>]:DECades:X? on page 372
●
CALCulate<n>:SNOise<s>[:TRACe<t>]:DECades:Y? on page 373
●
CALCulate<n>:SNOise<s>[:TRACe<t>]:Y? on page 374
FETCh<n>[:RANGe<j>]:PNOise<t>:DUT:GAIN?............................................................... 327
FETCh<n>:PNOise<t>:SPURs?...................................................................................... 328
FETCh<n>:PNOise<t>:SPURs:COUNt?...........................................................................328
FETCh<n>:PNOise<t>:SPURs:DISCrete?........................................................................ 329
FETCh<n>:PNOise<t>:SPURs:JITTer?............................................................................ 329
FETCh<n>:PNOise<t>:SPURs:RANDom?........................................................................329
FETCh<n>[:RANGe<j>]:PNOise<t>:IPN?......................................................................... 330
FETCh<n>[:RANGe<j>]:PNOise<t>:RAM?....................................................................... 330
FETCh<n>[:RANGe<j>]:PNOise<t>:RFM?........................................................................331
FETCh<n>[:RANGe<j>]:PNOise<t>:RMS?....................................................................... 331
FETCh<n>[:RANGe<j>]:PNOise<t>:RPM?....................................................................... 332
MMEMory:STORe<n>:SPURs.........................................................................................332
[SENSe:]BWIDth:MEASurement?....................................................................................332
TRACe<n>[:DATA]?....................................................................................................... 333
TRACe<n>[:DATA]:LINear?.............................................................................................333
TRACe<n>:POINts?.......................................................................................................335
TRACe<n>[:DATA]:X?.................................................................................................... 335
TRACe<n>[:DATA]:X:POINts?.........................................................................................335
TRACe<n>[:DATA]:Y?.................................................................................................... 336
TRACe<n>[:DATA]:Y:POINts?......................................................................................... 336
FETCh<n>[:RANGe<j>]:PNOise<t>:DUT:GAIN?
This command queries the DUT gain.
The DUT gain is the ratio of the power measured at the DUT output and the power
applied to the DUT input.
Measurements and Result Displays