Getting Started
R&S
®
FSPN
18User Manual 1179.4363.02 ─ 01
●
Class A equipment is intended for use in industrial environments. It can cause
radio disturbances in residential environments due to possible conducted and radi-
ated disturbances. It is therefore not suitable for class B environments.
If class A equipment causes radio disturbances, take appropriate measures to
eliminate them.
3.1.4 Setting Up the R&S FSPN
The R&S FSPN is designed for use on a bench top or in a rack.
See also:
●
"Setting up the product" on page 12
●
"Intended use" on page 11
3.1.4.1 Placing the Product on a Bench Top
To place the product on a bench top
1. Place the product on a stable, flat and level surface. Ensure that the surface can
support the weight of the product. For information on the weight, see the data
sheet.
2.
WARNING! A stack of products can fall over and cause injury. Never stack more
than two products. Otherwise, mount them in a rack.
Stack as follows:
● All products must have the same dimensions (width and length).
● Do not exceed a total load of 50 kg placed on the product at the bottom of the
stack.
Left
= Stacked correctly
Right = Stacked incorrectly, too many products
3.
NOTICE! Overheating can damage the product.
Prevent overheating as follows:
Preparing for Use
To Next Page
Loading...
