R&S FSPN - Trace<N>:Points; Trace<N>[:Data]:X; Trace<N>[:Data]:X:points

Remote Control
R&S
®
FSPN
335User Manual 1179.4363.02 ─ 01
TRACe<n>:POINts? <Trace>
This command queries the number of measurement points of a specific trace.
Suffix:
<n>
.
1..n
Window
Query parameters:
<Trace> TRACe1 | TRACe2 | TRACe3 | TRACe4 | TRACe5 | TRACe6 |
XGINdicator
"XGINdicator" only available for phase noise measurements.
Return values:
<Points> <numeric value> (integer)
Example: //Query number of measurement points of a trace in window 2
TRAC2:POIN? TRACE1
Usage: Query only
TRACe<n>[:DATA]:X? <Trace>
Queries X trace values merged with spurs for a given window and trace.
Suffix:
<n>
.
1..n
Window
Query parameters:
<Trace> TRACe1 | TRACe2 | TRACe3 | TRACe4 | TRACe5 | TRACe6
Return values:
<Result> Comma separated list of X values
Usage: Query only
Manual operation: See "Noise Diagram" on page 88
TRACe<n>[:DATA]:X:POINts? <Trace>
Queries number of points of trace data merged with spurs.
Suffix:
<n>
.
1..n
Window
Query parameters:
<Trace> TRACe1 | TRACe2 | TRACe3 | TRACe4 | TRACe5 | TRACe6
Return values:
<Points> <numeric value> (integer)
Usage: Query only
Manual operation: See "Noise Diagram" on page 88
Measurements and Result Displays