R&S FSPN - Configuring HUMS

Remote Control
R&S
®
FSPN
497User Manual 1179.4363.02 ─ 01
OFF | 0
Remote commands that cause changes to the hardware are
only executed when the SYSTem:SHIMmediate ONCE com-
mand is executed.
ON | 1
Remote commands are always executed immediately when they
are received by the instrument.
*RST: 1
Example:
SYST:SHIM:STAT ON
...
SYST:SHIM ONCE
Manual operation: See "Set Hardware Immediately" on page 285
SYSTem:SHIMmediate ONCE
Executes any received remote commands that cause changes to the hardware and
have not been executed yet due to a SYST:SHIM:STAT OFF command.
Example:
SYST:SHIM:STAT ON
...
SYST:SHIM ONCE
Usage: Event
Manual operation: See "Set Hardware Immediately" on page 285
11.9.6 Configuring HUMS
This section includes all commands needed for R&S HUMS remote operations.
DIAGnostic:HUMS:DELete:ALL....................................................................................... 498
DIAGnostic:HUMS:FORMat............................................................................................ 498
DIAGnostic:HUMS:STATe............................................................................................... 498
DIAGnostic:HUMS:TAGS:ALL?....................................................................................... 498
DIAGnostic:HUMS:TAGS:DELete:ALL..............................................................................499
DIAGnostic:HUMS:TAGS:DELete.................................................................................... 499
DIAGnostic:HUMS:TAGS[:VALue]....................................................................................499
SYSTem:COMMunicate:REST:ENABle.............................................................................500
SYSTem:COMMunicate:SNMP:COMMunity:RO................................................................ 500
SYSTem:COMMunicate:SNMP:COMMunity:RW................................................................500
SYSTem:COMMunicate:SNMP:CONTact..........................................................................500
SYSTem:COMMunicate:SNMP:LOCation......................................................................... 501
SYSTem:COMMunicate:SNMP:USM:USER......................................................................501
SYSTem:COMMunicate:SNMP:USM:USER:ALL?............................................................. 501
SYSTem:COMMunicate:SNMP:USM:USER:DELete.......................................................... 502
SYSTem:COMMunicate:SNMP:USM:USER:DELete:ALL................................................... 502
SYSTem:COMMunicate:SNMP:VERSion..........................................................................502
Configuring the R&S
FSPN