R&S FSPN - Page 500

Remote Control
R&S
®
FSPN
500User Manual 1179.4363.02 ─ 01
SYSTem:COMMunicate:REST:ENABle <RestState>
This command returns information about the HUMS REST status and enables or disa-
bles the public HUMS REST endpoints.
Parameters:
<RestState> ON | OFF | 0 | 1
Example: //Return REST state
SYST:COMM:REST:ENAB?
SYSTem:COMMunicate:SNMP:COMMunity:RO <CommunityString>
This command sets the SNMP community string for read-only access.
Prerequisites for this command:
●
Select an SNMP version that supports communities (SYSTem:COMMunicate:
SNMP:VERSion on page 502).
Setting parameters:
<CommunityString> String containing the community name.
Example: //Set community name
SYST:COMM:SNMP:VERS V12
SYST:COMM:SNMP:COMM:RO 'ABC'
Usage: Setting only
SYSTem:COMMunicate:SNMP:COMMunity:RW <CommunityString>
This command sets the SNMP community string for read-write access.
Prerequisites for this command:
●
Select an SNMP version that supports communities (SYSTem:COMMunicate:
SNMP:VERSion on page 502).
Setting parameters:
<CommunityString> String containing the community name.
Example: //Set read-write access
SYST:COMM:SNMP:VERS V12
SYST:COMM:SNMP:COMM:RW 'ABC'
Usage: Setting only
SYSTem:COMMunicate:SNMP:CONTact <SnmpSysContact>
This command sets the SNMP contact information for the administrator.
Not setting the contact information via SCPI persistently allows to change the string via
SNMP.
Configuring the R&S
FSPN