R&S FSPN - Page 324

Remote Control
R&S
®
FSPN
324User Manual 1179.4363.02 ─ 01
CONFigure:SNTune:MEASurement[:STATe] <State>
This command selects the Spot Noise vs Tune measurement.
●
To select the VCO characterization measurement, use CONFigure:VCO:
MEASurement[:STATe].
●
To select the Transient Analysis measurement, use CONFigure:TRANsient:
MEASurement[:STATe].
●
To select other measurements, use CONFigure:PNOise:MEASurement.
Parameters:
<State> ON | 1
Selects the Spot Noise vs Tune measurement.
OFF | 0
Selects the Phase Noise measurement (CONF:PNO:MEAS
PNO).
*RST: OFF
Example: //Select the phase noise measurement
CONF:VCO:MEAS OFF
Manual operation: See "Spot noise vs tune" on page 87
CONFigure:TRANsient:MEASurement[:STATe] <State>
This command selects the PN Transient Analysis measurement.
●
To select the Spot Noise vs Tune measurement, use CONFigure:SNTune:
MEASurement[:STATe].
●
To select the VCO characterization measurement, use CONFigure:VCO:
MEASurement[:STATe].
●
To select other measurements, use CONFigure:PNOise:MEASurement.
Parameters:
<State> ON | 1
Selects the PN Transient Analysis measurement.
OFF | 0
Selects the Phase Noise measurement (CONF:PNO:MEAS
PNO).
*RST: OFF
Example: //Select the phase noise measurement
CONF:VCO:MEAS OFF
Manual operation: See "PN Transient analysis" on page 87
CONFigure:VCO:MEASurement[:STATe] <State>
This command selects the VCO Characterization measurement.
Measurements and Result Displays