R&S FSPN - Page 345

Remote Control
R&S
®
FSPN
345User Manual 1179.4363.02 ─ 01
Parameters:
<Voltage/Current> <numeric value>
The type of value depends on whether you control the output in
terms of current or voltage (SOURce:VOLTage:POWer<i>:
LEVel:MODE).
When you control it in terms of voltage, the value is a voltage
(V). When you control it in terms of current, the value is the cur-
rent (A).
Range: 0 to 16 V or 2000 mA
*RST: 0 V or 2000 mA
Default unit: V or A
Example: //Define an output voltage of 1 V on the V
supply
source
SOUR:VOLT:POW:LEV:AMPL 1
Manual operation: See "Defining the output level" on page 125
SOURce:VOLTage:POWer<i>:LEVel:LIMit:HIGH
<Voltage/Current>
This command defines the maximum voltage that may be supplied by the V
supply
source.
Suffix:
<i>
.
1..n
irrelevant
Parameters:
<Voltage/Current> <numeric value>
The type of value depends on whether you control the output in
terms of current or voltage (SOURce:VOLTage:POWer<i>:
LEVel:MODE).
When you control it in terms of voltage, the value is a voltage
(V). When you control it in terms of current, the value is the cur-
rent (A).
Range: 0 to 16 V or 2000 mA
*RST: 16 V or 2000 mA
Default unit: V or A
Example: //Define a maximum current of 1000 mA
SOUR:VOLT:POW:LEV:LIM:HIGH 1000MA
Manual operation: See "Defining the output level" on page 125
SOURce:VOLTage:POWer<i>:LEVel:LIMit:LOW <Voltage/Current>
This command defines the minimum voltage that may be supplied by the V
supply
source.
Suffix:
<i>
.
irrelevant
Common Measurement Settings