R&S FSPN - Page 338

Remote Control
R&S
®
FSPN
338User Manual 1179.4363.02 ─ 01
Manual operation: See " Input Coupling " on page 100
INPut<ip>:SELect <Source>
This command selects the signal source for measurements, i.e. it defines which con-
nector is used to input data to the R&S FSPN.
Suffix:
<ip>
.
1 | 2
irrelevant
Parameters:
<Source> RF
Radio Frequency ("RF INPUT" connector)
*RST: RF
Manual operation: See " Radio Frequency State " on page 99
INPut<1|2>:LOSCillator:SOURce <Location>
This command selects the type of local oscillator in the test setup.
Suffix:
<1|2>
.
1|2
irrelevant
Parameters:
<Location> EXTernal
External local oscillator connected to the "LO AUX Input" of the
R&S FSPN.
INTernal
Internal local oscillator of the R&S FSPN.
*RST: INTernal
Example: //Select external oscillator
CONF:PNO:MEAS RES
INP:LOSC:SOUR EXT
Manual operation: See "Local Oscillator" on page 100
INPut<1|2>:LOSCillator:SOURce:EXTernal:LEVel <Level>
This command selects the level of an external LO signal that is fed into the R&S FSPN.
Suffix:
<1|2>
.
1|2
irrelevant
Parameters:
<Level> HIGH
LO signal with high level characteristics.
Common Measurement Settings