R&S FSPN - Page 180

Common Analysis and Display Functions
R&S
®
FSPN
180User Manual 1179.4363.02 ─ 01
Y-Axis ......................................................................................................................... 180
Data Points .................................................................................................................181
Insert Value ................................................................................................................ 181
Delete Value ...............................................................................................................181
Shift x ......................................................................................................................... 181
Shift y ......................................................................................................................... 181
Save ...........................................................................................................................181
Name
Defines the limit line name. All names must be compatible with Windows conventions
for file names. The limit line data is stored under this name (with a .LIN extension).
Remote command:
CALCulate<n>:LIMit<li>:NAME on page 446
Comment
Defines an optional comment for the limit line.
Remote command:
CALCulate<n>:LIMit<li>:COMMent on page 442
X-Axis
Describes the horizontal axis on which the data points of the limit line are defined.
Includes the following settings:
●
Unit:
– "Hz" : for frequency domain
– "s" : for time domain
●
Scaling mode: absolute or relative values
Not supported
●
Scaling: linear or logarithmic
Remote command:
CALCulate<n>:LIMit<li>:LOWer:MODE on page 445
CALCulate<n>:LIMit<li>:UPPer:MODE on page 447
CALCulate<n>:LIMit<li>:CONTrol:DOMain on page 443
CALCulate<n>:LIMit<li>:CONTrol:SPACing on page 444
Y-Axis
Describes the vertical axis on which the data points of the limit line are defined.
Includes the following settings:
●
Level unit
●
Scaling mode: absolute or relative (dB/%) values
Relative limit values refer to the center frequency (frequency diagram) or the refer-
ence value (phase diagram).
●
Limit type: upper or lower limit; values must stay above the lower limit and below
the upper limit to pass the limit check
Remote command:
CALCulate<n>:LIMit<li>:UNIT on page 446
CALCulate<n>:LIMit<li>:LOWer:SPACing on page 446
CALCulate<n>:LIMit<li>:UPPer:SPACing on page 448
Limit Lines