Common Analysis and Display Functions
R&S
®
FSPN
179User Manual 1179.4363.02 ─ 01
Traces to be Checked
Defines which traces are automatically checked for conformance with the limit lines. As
soon as a trace to be checked is defined, the assigned limit line is active. One limit line
can be activated for several traces simultaneously. If any of the "Traces to be
Checked" violate any of the active limit lines, a message is indicated in the diagram.
Remote command:
CALCulate<n>:LIMit<li>:TRACe<t>:CHECk on page 441
Comment
An optional description of the limit line.
Included Lines in Overview ( View Filter )
Defines which of the stored lines are included in the overview.
"Show Com-
patible"
Only compatible lines
Whether a line is compatible or not is indicated in the Compatibility
setting.
"Show All"
All stored limit lines with the file extension .LIN in the limits sub-
folder of the main installation folder (if not restricted by "Show Lines
for all Modes" setting).
Create New Line
Creates a new limit line.
Edit Line
Edit an existing limit line configuration.
Copy Line
Copy the selected limit line configuration to create a new line.
Remote command:
CALCulate<n>:LIMit<li>:COPY on page 439
Delete Line
Delete the selected limit line configuration.
Remote command:
CALCulate<n>:LIMit<li>:DELete on page 439
Disable All Lines
Disable all limit lines in one step.
Remote command:
CALCulate<n>:LIMit<li>:STATe on page 440
7.5.2.2 Limit Line Details
Access: "Overview" > "Analysis" > "Lines" > "Limit Lines" > "New" / "Edit" / "Copy To"
Name ..........................................................................................................................180
Comment ....................................................................................................................180
X-Axis .........................................................................................................................180
Limit Lines
To Next Page
