R&S FSPN - Page 178

Common Analysis and Display Functions
R&S
®
FSPN
178User Manual 1179.4363.02 ─ 01
7.5.2.1 Limit Line Management
Access: "Overview" > "Analysis" > "Lines" > "Limit Lines"
For the limit line overview, the R&S FSPN searches for all stored limit lines with the file
extension .LIN in the limits subfolder of the main installation folder. The overview
allows you to determine which limit lines are available and can be used for the current
measurement.
For details on settings for individual lines see Chapter 7.5.2.2, "Limit Line Details",
on page 179.
For more basic information on limit lines see Chapter 7.5.1, "Basics on Limit Lines",
on page 174.
Name ..........................................................................................................................178
Unit .............................................................................................................................178
Compatibility ...............................................................................................................178
Visibility ...................................................................................................................... 178
Traces to be Checked ................................................................................................ 179
Comment ....................................................................................................................179
Included Lines in Overview ( View Filter )................................................................... 179
Create New Line ........................................................................................................ 179
Edit Line ..................................................................................................................... 179
Copy Line ...................................................................................................................179
Delete Line .................................................................................................................179
Disable All Lines .........................................................................................................179
Name
The name of the stored limit line.
Unit
The unit in which the y-values of the data points of the limit line are defined.
Compatibility
Indicates whether the limit line definition is compatible with the current measurement
settings.
For more information on which conditions a limit line must fulfill to be compatible, see
"Compatibility" on page 174.
Visibility
Displays or hides the limit line in the diagram. Up to 8 limit lines can be visible at the
same time. Inactive limit lines can also be displayed in the diagram.
Remote command:
CALCulate<n>:LIMit<li>:LOWer:STATe on page 440
CALCulate<n>:LIMit<li>:UPPer:STATe on page 442
CALCulate<n>:LIMit<li>:ACTive? on page 438
Limit Lines