R&S FSPN - Page 442

Remote Control
R&S
®
FSPN
442User Manual 1179.4363.02 ─ 01
CALCulate<n>:LIMit<li>:UPPer:STATe <State>
This command turns an upper limit line on and off.
Before you can use the command, you have to select a limit line with CALCulate<n>:
LIMit<li>:NAME on page 446.
Suffix:
<n>
.
irrelevant
<li> Limit line
Parameters:
<State> ON | OFF | 0 | 1
OFF | 0
Switches the function off
ON | 1
Switches the function on
Manual operation: See " Visibility " on page 178
11.7.5.2 Designing Limit Lines
CALCulate<n>:LIMit<li>:COMMent.................................................................................. 442
CALCulate<n>:LIMit<li>:CONTrol[:DATA]......................................................................... 443
CALCulate<n>:LIMit<li>:CONTrol:DOMain........................................................................443
CALCulate<n>:LIMit<li>:CONTrol:MODE..........................................................................443
CALCulate<n>:LIMit<li>:CONTrol:SHIFt........................................................................... 444
CALCulate<n>:LIMit<li>:CONTrol:SPACing...................................................................... 444
CALCulate<n>:LIMit<li>:LOWer[:DATA]............................................................................445
CALCulate<n>:LIMit<li>:LOWer:MODE............................................................................ 445
CALCulate<n>:LIMit<li>:LOWer:SHIFt..............................................................................445
CALCulate<n>:LIMit<li>:LOWer:SPACing.........................................................................446
CALCulate<n>:LIMit<li>:NAME........................................................................................446
CALCulate<n>:LIMit<li>:UNIT......................................................................................... 446
CALCulate<n>:LIMit<li>:UPPer[:DATA].............................................................................447
CALCulate<n>:LIMit<li>:UPPer:MODE.............................................................................447
CALCulate<n>:LIMit<li>:UPPer:SHIFt.............................................................................. 447
CALCulate<n>:LIMit<li>:UPPer:SPACing..........................................................................448
CALCulate<n>:LIMit<li>:COMMent <Comment>
This command defines a comment for a limit line.
Suffix:
<n>
.
irrelevant
<li> Limit line
Parameters:
<Comment> String containing the description of the limit line.
Manual operation: See " Comment " on page 180
Common Analysis and Display Functions