R&S FSPN - Page 378

Remote Control
R&S
®
FSPN
378User Manual 1179.4363.02 ─ 01
[SENSe:]SPURs:FILTer:RANGe <Range>
This command defines the range of the spurious filter. The range is defined as a multi-
ple of the resolution bandwidth.
Parameters:
<Range>
Example:
SENS:SPUR:FILT:RANG 1
Manual operation: See "Filtering spurs" on page 121
[SENSe:]SPURs:FILTer:NAME?
This command returns the name of the selected spurious filter.
Example:
SENS:SPUR:FILT:NAME?
Usage: Query only
Manual operation: See "Filtering spurs" on page 121
[SENSe:]SPURs:FILTer:OFFSet <OffsetValues>...
This command creates a new offset table with defined frequency ranges.
Parameters:
<OffsetValues> Default unit: Hz
Example:
SENS:SPUR:FILT:OFFS 1.3e3, 2.6e5
Manual operation: See "Filtering spurs" on page 121
[SENSe:]SPURs:FILTer:CLEar
This command clears the currently selected spurious filter.
Example:
SENS:SPUR:FILT:CLE
Usage: Event
Manual operation: See "Filtering spurs" on page 121
[SENSe:]SPURs:FILTer:SAVE <Filename>
This command saves the spurious filter configuration to a file. The spurious filter name
can be defined.
Location of filter files: C:\R_S\instr\SpuriousFilter\
Setting parameters:
<Filename>
Example:
SENS:SPUR:FILT:SAVE "MyFile"
Usage: Setting only
Common Measurement Settings